GR-910 / Flat annular ring
Raised-Face Ring Gasket
R0 preliminary technical dataAnnular cut gasket located inside the flange bolt circle.
Product intent
GR-910 selection basis
A simple ring gasket cut to the mating raised-face geometry. Material and thickness depend on media, temperature, bolt load and flange condition.
| Reference geometry | ID x OD x thickness |
|---|---|
| Joint type | Raised-face bolted flange |
| Release status | R0 preliminary - engineering approval required |
| Dimensional control | Drawing-specific; inspection plan issued with approved quotation |
| Material validation | Media, temperature, pressure and duty cycle review required |
| Traceability | Lot and compound traceability available by contract |
Release boundary: this page and its PDF are selection aids. Do not manufacture, install or rate a component from R0 data.